InterVLAN Routing
Switch>ena
Switch#conf t
Switch(config)#vlan 10
Switch(config-vlan)#name dosen
Switch(config-vlan)#exit
Switch(config)#vlan 20
Switch(config-vlan)#name mahasiswa
Switch(config-vlan)#exit
Switch(config)#int fa0/1
Switch(config-if)#switchport access vlan 10
Switch(config-if)#exit
Switch(config)#int fa0/2
Switch(config-if)#switchport access vlan 20
Switch(config-if)#exit
Switch(config)#int fa0/23
Switch(config-if)#switchport mode trunk
Switch(config-if)#exit
Switch(config)#int fa0/24
Switch(config-if)#switchport mode trunk
Switch(config-if)#exit
Konfigurasi Switch1:
Switch>ena
Switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#vlan 10
Switch(config-vlan)#name dosen
Switch(config-vlan)#exit
Switch(config)#vlan 20
Switch(config-vlan)#name mahasiswa
Switch(config-vlan)#exit
Switch(config)#int fa0/1
Switch(config-if)#switchport access vlan 10
% Access VLAN does not exist. Creating vlan 10
Switch(config-if)#exit
Switch(config)#int fa0/2
Switch(config-if)#switchport access vlan 20
% Access VLAN does not exist. Creating vlan 20
Switch(config-if)#exit
Switch(config)#int fa0/24
Switch(config-if)#switchport mode trunk
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/24, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/24, changed state to up
Switch(config-if)#exit
Konfigurasi Router0:
Continue with configuration dialog? [yes/no]: no
Press RETURN to get started!
Router>ena
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#int fa0/0
Router(config-if)#no ip add
Router(config-if)#no sh
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Router(config-if)#exit
Router(config)#int fa0/0.10
%LINK-5-CHANGED: Interface FastEthernet0/0.10, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0.10, changed state to up
Router(config-subif)#encapsulation dot1q 10
Router(config-subif)#ip add 192.168.10.1 255.255.255.0
Router(config-subif)#exit
Router(config)#int fa0/0.20
%LINK-5-CHANGED: Interface FastEthernet0/0.20, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0.20, changed state to up
Router(config-subif)#encapsulation dot1q 20
Router(config-subif)#ip add 192.168.20.1 255.255.255.0
Router(config-subif)#exit
Comments
Post a Comment